prosimparts radio modules

Thanks Ed it now works I hadn't done numerical config that was why! can I ask whats the difference with 1x 2x 4x on the encoder page and is 1x ok as you showed in your picture?
thnks again.

Hi,

Good to hear you succeeded!

These numbers are used to fit in a correct rotation of your encoder knob. Just try it for your own needs. You shall see that the difference between them results in a fast and slower change of the display notation. I have set it up that it will change notation after 2 clicks of the knob (read encoder).

Does this make sense for you? Don't hesitate to ask.

Best regards!

Thanks that makes sense.