Battery voltage in overhead

My battery voltage indicators in my hardware overhead usually read zero but occasionally 28 volts.
They always worked fine with my previous software and are driven by SIOC as follows:

// Batt voltage in overhead


Var 0115, Link FSUIPC_IN, Offset $4650, Length 2 // BATT 1
{
L0 = V0115
V0116 = L0
}
Var 0116, Link IOCARD_DISPLAY, Digit 64, Numbers 3 // BATT 1 Display



Var 0117, Link FSUIPC_IN, Offset $4652, Length 2 // BATT 2
{
L0 = V0117
V0118 = L0
}
Var 0118, Link IOCARD_DISPLAY, Digit 67, Numbers 3 // BATT 2 Display

Anyone got any ideas?
Barry

Try the sioc_creator. It's much easier to assign the displays.
It works fine also in the new release.

I understand that I could start again on my SIOC routines but they have been working OK for 8 years and I could do without the work. I was just trying to understand why my proven routine works sometimes and not others with JH.
Barry

Barry,
Have you checked to see when JH soft is run if there is a .ssi file that JL has run
automatically that may be using variables that you already use.
Regards
Les