Thrust Lever Problem

Hello:)
I've got a little problem with my Jeehell FMGS Thrust Lever. When I try to start the engines, the ECAM says:" Start Fault, THR Lever not at IDLE ", but it is on IDLE.:?: So I have a Screenshoot to show my problem exactly.
Yours faithfully Pablohttp://www.mycockpit.org/forums/atta...id=10246&stc=1

Try using an error zone of 1 in the joystick configure program if you are using the software based throttle lever.

I have this too, but a quick wiggle of the throttles clears it. I keep meaning to go into the FMGS_config utility to increase the error margin but it's not high on the list.

Pablo,

Jut to make sure, you did calibrate the throttle module in the FMGS Config? even if it's software based, it needs the calibration process.

JL

I have actual the same problem. I am using the Saitek Throttle Quadrant and Thrustmaster Joystick T.16000M.
To allocate what device is working wrong, I switched off first Saitek and than Thrustmaster. But the error message is still the same (without any device on PC).
Furthermore with Throttlequdrant I am not able the increase or decrease power.