Printable View
I have set up my PM sytem and it works just fine with my Flyengravity FW overhead panel.
But my respones from my HW is too slow, it takes about a 2-3 sec. when I Operate a switch and to the response from Pmsystem occures?(I have a screen setup so i see when the operation happens)
I have reduced the cycle to 60 on both places in the menu but still its to slow.
Any thoughts on this would be greatly appreciated.....:roll:
hi, some recomendations,
PM system will be on a good computer, and a good graphic card (medium)
NO dinamic Ip, static IP.
LAn, not wifi conection
same cable Lan for all comunications
disable on the PC all the recomendations of PM.
no 10/10 card lan, 100 in mode full dublex, (better 1000)
...only a few ideas...
grettings,
Pablo
my response is missing from yesterday so im replying again :)
TX a static ip did the job, now the response is as fast as the click from the switch
A happy new year to everyone!
happy new year:)