Hello again.
Thanks to the help I received last time and many hours banging around with the few lights the Spitfire has, I have now managed to learn my way around FS2phidget.
I even managed to make all the lights conditional upon a master switch and THEN their independant switches/triggers.
However I have struck one problem. I am building the camera controllers for the PRU Spit and the Type 35 (that controls the actual taking of the photos) has a red light which goes on in between exposures then it goes out and a green light flashes as each exposure is taken.
Now obviously FSX doesn't support this but I would like to set a fixed cycle for these lights to operate at whenever the main Type 35 switch is turned on.
So I set up two outputs up (conditional upon the main circuit being open..software valve) and wired them through the physical switch...no switch, no power so what FSX does is irrelevant. So now they come on all the time once the physical and software circuits are BOTH on.
But I can't get them to flash on the fixed cycle, or in fact at all. I see the Flash set to true and I can set a rate .... but it does not seem to have any effect?
I have read the manual (5.021) for Flash but it just seems to say what I am doing already?
Can someone give me a lead....??
cheers
Darryl