PDA

View Full Version : Ideas for throttle handles



tunatuk
04-29-2007, 04:34 PM
..........

JBaymore
04-29-2007, 06:08 PM
tunatuk,

Cut some PVC pipe of the right diameter into sections that are the right length. Get some stainless steel bolts of the right size in both length and diameter. Get a package of epoxy plumber's putty. Fill the section of pipe with the kneaded putty, pressing down on a flat table surface to finish the ends. CAREFULLY press the bolt into the center of the putty on one end, leaving the correct amount projecting to mount to the handles. Let it set. Use a dremel and 320 grit wet/dry SiC paper to clean up any nasties. Spray paint....and mount.

best,

....................john

Geremy Britton
08-15-2007, 09:47 AM
try some handles from a diy store or failing that use some empty cotton reels they dont even need painting and have a hollow middle to easily wire switches autopilot etc in them! :D

Michael Carter
08-15-2007, 10:24 AM
I used Delrin rod. I had a friend turn them on a lathe for me to the proper shape.

You could also use wooden dowel rod.

Trevor Hale
08-15-2007, 11:50 AM
I used wooden dowling rod, and turned them on my lathe. Easy as pie if you have access to such a thing.

Trev

PilotoX
11-23-2007, 02:03 PM
Use Bike Handlebar handles nice and rubbery ones?

Is anyone using these?

Joe Cygan
11-23-2007, 02:12 PM
There are many ways to build them yourself but if you ever decide that you need to buy them I do have a full set of knobs for most aircraft coming out very soon. I would me more than happy to help you.
http://i9.tinypic.com/85fbcs5.jpg

Jackpilot
11-23-2007, 03:56 PM
Check :
http://shop.strato.de/epages/15465782.sf/en_IE/?ObjectPath=/Shops/15465782/Products/737-TH-001


Not expensive and ready to go.

manhattan
12-02-2007, 05:17 PM
Alright, I'm building a TQ based off of an old logitech wingman joystick. I have the framework all mapped out, and have the pots and everything, but I have no idea at all what I could use for handles.

anyone have any ideas?

BROOM HANDLE!!