PDA

View Full Version : Gear Lights



Bob Reed
04-07-2007, 07:52 PM
Ok all you Boeing drivers. I have my Gear annunciators all programed and working. Now for the question, how long do the red annunciators stay on after the gear locks in the up position? Or does it stay that way untill the gear is turned off and the hydolics are released in the gear?

Westozy
04-07-2007, 08:52 PM
I reckon they would stay on until the lever is put back to off. Can you explain how you made these lights work Bob? I know I will need an output module, but where do you go from there? I often read about offsets but no one has offered to explain this mystery to the mechanical engineer!

Gwyn

Bob Reed
04-07-2007, 09:32 PM
Well.... I am not using offsets to light them. I am using Qprocs. I am not sure your boards use them. If they don't I can try to tell you how to do it with an offset but it is not as easy but very doable. Does your drop down software have the gear in it? It is a pretty fundamental thing to want to do and I would think it would be in there.

pylet
04-07-2007, 10:42 PM
I found this text in the B737 Continental POH:

===================
Landing Gear Indicator Lights (Top)

Illuminated (red) –
· landing gear is not down and locked (with either or both forward thrust levers retarded to idle, and below 800 feet AGL).
· BCD landing gear is not down and locked (with either or both forward thrust levers retarded to idle and below 800 feet AGL).
· related landing gear is in disagreement with LANDING GEAR lever position (in transit or unsafe).

Extinguished -
· landing gear is up and locked with landing gear lever UP or OFF.
· landing gear is down and locked with landing gear lever DN.

Landing Gear Indicator Lights (bottom)

Illuminated (green) – related gear down and locked.
Note: Landing gear warning horn is deactivated with all gear down and locked.
Note: Landing gear is down and locked when a green landing gear indicator light (center panel) for each gear is illuminated.

Extinguished – landing gear is not down and locked.
===============

I couldn't find any timing information so as soon as the gear is safely up and locked then the red lights go out. Every plane is probably different in which gear gets up first and how fast or slow.

Lyle

Bob Reed
04-07-2007, 11:37 PM
Hi Lyle. That is what I wanted to know.. As soon as my gear is up and locked my lights go out and that is what it is supposed to do looks like!!:D

Westozy
04-08-2007, 01:34 AM
I think I would only see the Output drop down lists if I had an output module connected which I don't have yet. It's not on my immediate wish list I'm doing my overhead at the moment, also flap and speedbrake levers for Trevor!!!

Gwyn

Trevor Hale
04-08-2007, 08:37 AM
LOL, Gotta raise some money for that output board Gwyn. ... Thats why your doing the flap and speed brake :)