How to setup correct trim values

[hercules]

Hello all,

iam wondering about the trim setting in PM. When i activate the analog trimgauge it shows me wrong values. I know its possible to change the trim scal in PFD ini-file, but i don´t understand it.

The normal trim scal is from 0 to 17 units. When i use this value (default in many 737 aircraft files) so the PM gauge show the value 10 units and the real aircraft in FS shows me about 5 units

I have try many different scale settings, but i can´t find one that usable. Iam confused about thats, because i ask myself how i can fly without correct trim setup??? I tried many different 737 aircrafts in FS, all with the same success.

Also im wondering about the missing trim value in the takeoff page of the cdu? I can set the center of gravity value and the flaps, but don´t get a trim value. I thinks its really important for takeoff preparing and non catastrophic rotation of the airplane.

Hope anybody can help me and explain me this quesitions

Thanks a lot

Thomas

[Hans Krohn]

Hi Thomas,

what happens if you set everything to default? I mean, default FS 737-300 and default 737400.txt file?

I fly like that, and I have no issues with trim. Just make sure trim is set inside the green band in EICAS before takeoff (if it's not, you get the warning horn anyway...)

Best regards,
Hans

[hercules]

Hello Hans,

Thanks for the answer
Do you mean the analoge trimgauge in PFD software? I Think the default in PM is that no trimscale values available. When i start the software without trimscale entry i see a trimgauge from -40 - +40 on PM PFD. When i look on the trimscale on FS737 or PMDG 737 i see 0 -17. The values in the FS aircraft are correct, because when i set the PM scale into the green range i cant takeoff.

Strange
Thomas

[hercules]

Hi Thomas,

thanks for the info!

I know these settings, but it seems they dont work correctly, because
when i set the values just how you suggest, the PM Gauge show always 5 Parts higher tha the FS-Aircraft. This ist the problem i have.

Thomas

[hercules]

HI Thomas,

:-) We will find the solution. What i mean ist the following:

I use a modified PMDG 737-700. Since the Project Magenta software has nor calculation of trim seetings i use the PMDG FMC to calculate the correct trim value.

When i get e.g a trim value of 6.5 from the FMC, i can set this value to the PMDG own trim gauge and the takeoff works very well. But i cant find a trim scale setup that looks similar to the scale of the PMDG one and so i dont knwo whats here the correct trim scale value?.

Maybe i think to complicated.....and i cant use the PMDG calculated trim values within Project Magenta, but how else i can calculate the correct takeoff trim setup??

And is the PMDG´s calculation and trimscale not like a real 737-700?

Just for information...the calculation results are in al other 737 Addons the same....only Project Magenta looks different


Thomas

[dcutugno]

You are not alone, i have your same problem.

I hope in future PM cdu will calculate correct trim values and CG like pmdg cdu