52.4 and P3D4.5 - Installation problem

[SSO]

Hi all,

I have after some months break from Simming updated Jeehell to 52.4 with P3D 4.1. everything seemed to work fine.
I have then updated P3D4.1 to 4.5 (Client and Content).
Starting Jeehell Cold&Dark works ok - still with the A320-214.
However when trying to start the APU The flap opens but the APU itself does not start.

Does anybody have a clue what this might be?

Thanks in advance.

[michael1508]

works fine here with 4.5 and 52.4

Just to aasure... you pushed the APU Start button?
Do you use the soft Overhead or hardware?

[SSO]

Thanks - I have both hard and soft - they are correlated. It shows "FLAP OPEN" but after that it does not spool up.

Think it may be something to do with the 4.5 update rather than 52.4, but maybe someone else have experienced it!?

[Fabiano2012]

hi,

just a few thoughts...
are all key-assignments associated with apu cleared inside P3D ?
did you try to close one of your things to have only one working (only software panel or only hardware panel at a time) ?

[StevenBek]

Вы найдете самые не повторяющиеся солнцезащитные очки и аксессуары к ним. Оптика для тех, кто не гонится за супер моднымии кто понимает толк качества индивидуального стиля. В магазине продаются очки дешево Петропавловск-Камчатский (https://oookazanskii.ru) можно заказать ремонт очков любой сложности и любых видов.

[flykarli]

Hi ,
I had the same problem today. The solution is, when the sim in pause mode, then the apu does not start. Hope this helps.