Rudder Trim Offsets in 7 Seg Display driven from Jeehell via FSUIPC to Ardnuino/Mobiflight, help needed

[spaceweather]

Hi freaks,

i am coming from the Mobiflight Forum:
https://www.mobiflight.com/forum/topic/4116.html

I want to drive a 4 digit 7 segment display to show the rudder trim offset in Lower Pedestal.
They are connected to an Arduino Board, software on that is Mobilflight.

I need the right offsets. Does anyone know, if Jeehell supports these outputs and how to program the MF?

Regards
Andy

[flambinet]

Hi Andy,
I am not sure if I understand qour question right or if I am missing something.
There is an Offset for rudder trim in the .pdf file EN-Offsets, page 9/21, Folder A320FMGS.
This Offset is 73B1, 2 Bytes.
In MF, you will have to create a new device and enter this Offset in the related field. There are
tutorials on the web how to do this.
If you do this, it should work.
Good luck
Fritz

[spaceweather]

Hello Fritz,
yes thank you. I think i understand now. How to Display the R and L towards the Numbers?