USE MAN PITCH TRIM

[MBerger]

Hi,

I have this problem the second time and don't know why and how to fix it.

After programming the MCDU and starting the engines I get the warning message in upper ECAM:

F/CTR DIRECT LAW
(PROT LOST)
-MAN PITCH TRIM......USE

and in the PFD display: USE MAN PITCH TRIM

Why do I get this warning and how can I fix it?
The ATHR and AP are not working after take off...

Thanks for your help
Regards
Matthias

[MBerger]

http://www.mycockpit.org/forums/attachment.php?attachmentid=12443&stc=1http://www.mycockpit.org/forums/attachment.php?attachmentid=12444&stc=1http://www.mycockpit.org/forums/attachment.php?attachmentid=12445&stc=1
The Problem is since the actual Build. Before the last update I never had that problem.

[OmniAtlas]

Scan you overhead - no annunciator warnings or switches disabled? Check your hydraulics - all turned on? What does the ECAM page say? Have you turned battery 1 and 2 on?

[MBerger]

Sorry for the delayed answer, I made a few flights, but I did't have the obove described problem again until now.
As I remember there where no warnings at the overhead. All system where turned on...
I will post if I have the warning again.

[MBerger]

Hi,
today I had the message/problem again...
I checked the Overhead, every systems are turned on (also Bat1 and 2). No warnings (faults) and nothing to see there.
I get the following messages:
on the pfd below CLB and NAV the orange message:
- USE MAN PITCH TRIM
on the upper ECAM page:
- F/CTR DIRECT LAW (PROT LOST) (orange message)
- MAN PITCH TRIM.........USE (blue message)

on the lower ECAM page: (after pressing STS on ECAM panel)
left display side:
- MAX SPEED..................320/.77 (blue message)
- MAN PITCH TRIM..........USE (blue message)
- LDG DIST PROC...........APPLY (blue message)

- DIRECT LAW (green message)

right display side
INOP SYS
- F/CTL PROT (orange message)
- ELAC PITCH (orange message)

I try to attach some pics... but the last pics I wantet to attach never come online!

Regards
Matthias

[MBerger]

http://www.mycockpit.org/forums/attachment.php?attachmentid=12469&stc=1http://www.mycockpit.org/forums/attachment.php?attachmentid=12470&stc=1http://www.mycockpit.org/forums/attachment.php?attachmentid=12471&stc=1http://www.mycockpit.org/forums/attachment.php?attachmentid=12472&stc=1

[jeehell]

Check ADIRS alignment and FACs status

[MBerger]

Thank you for your fast answer.
The FAC`s on the overhead are on and have no faults.
The ADIRS I can't check, I have no hardware for it on the overhead, only a blind panel...

[OmniAtlas]

Thank you for your fast answer.
The FAC`s on the overhead are on and have no faults.
The ADIRS I can't check, I have no hardware for it on the overhead, only a blind panel...

Use the software overhead program to check.