No flaps

[mike24]

Since latest update
I have set up all levers again but for some reason flaps adjustment won't save all out her levers fine
Thankyou

[pete_fuss]

Since latest update
I have set up all levers again but for some reason flaps adjustment won't save all out her levers fine
Thankyou
Hello,
the same is by me,
sometimes the Flaps are at full position in the upper right display, but the landing memo is still flaps full in blue!

regards Peter

[mike24]

Flaps won't work at all
in the config it works but for some reason it's not saving
Please tell me what file uses to save config

[jeehell]

if you want help, you need to first tell us your hardware setup.
What neutral zone do you use?
Did you by any chance install mistakenly the software flaps panel? If so it will override your hardware commands...

[mike24]

Hi jeehell
Everything worked perfectly until the latest build although I had to set up all levers again
hardware is potentiometer with bogner card it is working in your config setup you can see the different readings of the pot as you move lever
neutral zone?
but not saving I have no software flaps panel installed

[jeehell]

in FMGS Config, in the flaps calibration window, you must input a neutral zone in %.
If it is not set, it will not work correctly.

You seem to be the only one having this issue, so I think it is not a bug but rather a user issue.

[mike24]

My neutral zone was the problem Thanks jeehell