No Spolier Reaction in P3D

[Tobia346]

Hello Community,

I am using JeeHell with Cockpitsonic hardware and in the hardware calibration window, the spoiler movement is visible and makes sense, while on P3D the Spoliers didn´t deploy manually, just on landing on armed Pos. What could be wrong here? Add: With the P3D command, they deploy.

Best regards and thanks in advance.

Tobi

[TheLever]

Hi Tobi,

At the risk of sounding like a besserwizer since I am new to Jeehell, I would take a look at the calibration again. I had almost the same issue and found that it was due to too small neutral error percentages. When I looked at the calibration, the spoilers looked just fine, but they were not behaving in flight. My fix was to increase the neutral error parentage. Joe this helps!

Thanks,
Boaz