recalculate TOD

[digidax]

On Version B44.4

Hi,
being in CRZ Phase on FL 310. The ATC asks to decent to FL 290. Turning ALT on Skalarki FCU from 31000 to 30000.
The A320 decend to FL 300. After 5 min ATC releases climb back to FL 310. But now the TOD arrow was gone away.

Is it possible to let the FMGS recalculate the TOD so I will see it on ND?

thanks and best regards
Frank

[jeehell]

Hi

Probably just changing the CRZ LVL to the new assigned level should work.

Regards
JL

[digidax]

Hi,
Thanks. Do I understood right, changing the CRZ level inside MCDU under PERF in setup of CRZ phase.
How long is the CRZ phase acessable?

best regards
Frank

[digidax]

Okay have found a very good documentation here for the Thales MCDU procedures:
http://www.737ng.co.uk/airbusfms.pdf

(http://www.737ng.co.uk/airbusfms.pdf)JL can you please confirm that the procedures of the manual behind the link is working with Jeehell FMGS?

best regards
Frank

[jeehell]

Hi,

This manual is the REV1, I use the REV2, but the principle is mostly the same.
Not everything is already implemented of course...

JL

[digidax]

Thanks JL,
this forum lives from helping user to user. This means also to share own experience about this great work of JL and support other if they maybe have the problem too. For this topic please see side 191 of the PDF file I have posted: link
(http://www.mycockpit.org/forums/showthread.php?t=30366&p=161683&viewfull=1#post161683)Pleas note the text at the end of the page.

best regards
Frank