Rebuilding A320 FCU, help with display needed

[Barrykensett]

I have been using an FDS A320 FCU for a few years with AST software. The USB interface card is made by CPFlight known as G2.
This card is not supported by Jeehell, the AST software is not very good and I am thinking of rebuilding the unit.
I know how to sort out encoders, pots and switches using Leo Bodnar cards and I can drive LEDS using either FDS output cards or Open Cockpits but I am not quite sure what is driving the display which has digits and also legends that light up. Perhaps this is just a series of 7 segment displays behind a mask with LEDS which I can do or perhaps it is a screen which I wouldn't know how to drive. Has anyone any tips on doing this please?
Picture below is a later version but is much the same as mine.
http://www.flightdecksolutions.com/images/made/assets/images/large_images/fds-a320-pro-mx-fcu-efis-1_546_239.jpg


Barry
www.a320sim.com (http://www.a320sim.com)

[jeehell]

Hi Barry,

I have seen a more recent version of FDS FCU, and it were standard 7 segments digits. Not sure how they were wired exactly though.

Regards
JL

[Barrykensett]

I think I see how it is done. Yes 7 digit displays, I know how to wire those up, there is also a mask with the labels for small leds for status. The overall effect looks like a single LCD screen but it is not. I can reproduce it I think but I won't know how easy until I open the unit up, if it is all on one board it may be tricky. I am keeping the sim flying on the old software as long as possible while changing over the systems but will soon only have the FCU to fix.
Barry
www.a320sim.com