To Alan : TQ working great, just need slower servo speed

[Saldo]

Thanks for your great program.
My motorized tq is working great with the latest v4 ( nov 13 )

The only thing I cannot achieve is a slower servo speed.
I have the servo speed set at 1 degree/sec but the speed is much faster.
In Fs itself the levers also move too fast, but I thought it could be modified in the program.
Is there something I can do ?

Thanks in advance.

[CocnutAir]

The servo speed setting should slow servo down. Sounds like is not working properly. Let me check that and get back to you.

Regards,
Alan

[Saldo]

That would be very kind of you Alan.
Thanks in advance.

( v 4.393 )

[CocnutAir]

I am assuming you are using the advanced servo card.

[Saldo]

The card is a 1061_1 AdvancedServo 8 card

[CocnutAir]

The setting for max slew rate was set up to set speed for older Phidget Servo card. Doesn't do a whole lot now. I have added ability to set Acceleration and Velocity for the Advanced Servo. Have not tested against servo because it's -2C degrees in my garage right now. Send me a PM with your email and I will send you an updated version.

Regards,
Alan

[Saldo]

Hi Alan,

PM has been sent.

Regards,
Gerard