jketelings
04-08-2014, 01:55 PM
Hello,
Today I took one of the fuel flow gauges out of the cockpit from our dead beech 200 sim at school to see how it worked. It had two connections and if I applied approximately 45mV on it, the gauge indicated zero. If I applied approx 0.8V on it, the gauge indicated maximum.
So I wonder, how I am going to make i.e FSX drive this gauge?
Regards,
Jeffrey
Today I took one of the fuel flow gauges out of the cockpit from our dead beech 200 sim at school to see how it worked. It had two connections and if I applied approximately 45mV on it, the gauge indicated zero. If I applied approx 0.8V on it, the gauge indicated maximum.
So I wonder, how I am going to make i.e FSX drive this gauge?
Regards,
Jeffrey