Pumpie
07-08-2013, 06:41 AM
Hi,
I need some help with LINDA and buttons programming:
My ignition select switch is connected to the board as an axis(three positions- 0%, 50% and 100%)
Since LINDA won't support axis i can't set each position to send command
How could I figure it out?
Thank you in advance
I need some help with LINDA and buttons programming:
My ignition select switch is connected to the board as an axis(three positions- 0%, 50% and 100%)
Since LINDA won't support axis i can't set each position to send command
How could I figure it out?
Thank you in advance