FDS-SYS2X High Capacity (128Input Card) - Pots and rotary encorders

[freddehboy]

Hi

I have look at the above card to these components, see bellow:
37x on/off switch 37 digital pins
9x on/off/on switch 18 digital pins
6x mom/off/mom switch 12 digital pins
1x on/off/mom switch 2 digital pins
2x Rotary encorders, 24-steps 4 digital pins
12x Rotary switch 50 digital pins
8x Rotary potentiometer

I know that the cards do not work with "Rotary potentiometer" and "Rotary encorders"!

My questions are:
1.)
Are there some card who support thise components?

2.)
A regular joystick card does like Leobodnar. I must however be able to connect the card and control it through FSUIPC since pmdg 737ngx are handle controls from hardware through offset!

The question is: Am I able to link a normal joystick buttom throught FSUIPC and offsett?
--------------------------------------------------------------------------------------------------------

The goal is with my 8 pots to control lights in the cockpit and with the rotary encorder control the ALT landing and FLT ALT!

Please answer this or give a tips on where to search?!

Best Fredrik

[jonesthesoftware]

the Leo Bodnar card supports pots and encoders and so does the Open Cockpit cards and both can be used with FSUIPC
You need 1 Leo Bodnar BU8036 (takes 8 pots) or 1 sub card and 1 master card from OC
regards
geoff

[freddehboy]

Hi

Thank you but can leo with FSUIPC be ling to a offsett so you can control a function in pmdg737ngx through its´offsett?

[freddehboy]

Hi

I have now find the way that I can use to link it :)

Fredrik

[nolatron]

Hi

Thank you but can leo with FSUIPC be ling to a offsett so you can control a function in pmdg737ngx through its´offsett?

With the Bodnar card and FSUIPC, you can use the 737NGX SDK Control Codes in FSUIPC to control all the 737NGX Switches.

[freddehboy]

Hi

Do you mean via control events nr of pmdg 737ngx?

[nolatron]

Hi

Do you mean via control events nr of pmdg 737ngx?

Yeah, see here for some info on the NGX Control Codes: 737NGX Control Codes (http://www.blueskies737.com/737ngx-control-codes/)

[freddehboy]

Hi

I have make my decisions to use: Universal 12-Bit Joystick Controller BU0836X (http://www.leobodnar.com/products/BU0836X/)

For all of my 120 inputs both analog potetiometers and the two rotary encorders :)

1a,)
I have read that you can share the GND input to all of the button inputs "(GND can be shared between inputs if necessary.)" It is valid to the whole board or must the digital and analog gnd be separate?


2,)
I am needing to make about 120 inputs digital and analog inputs in fsuipc, is thera a more easier way than to link a button in fsuipc than the general way?

Best Fredrik