PDA

View Full Version : Logistics of fitting LCD's behind MIP



StephenBalmer
08-06-2012, 05:05 PM
Hi Folks,

I hope all is good with you.

Just considering now the placement of the LCD screens behind my MIP.

Am I correct in thinking that you remove the actual LCD panel completely from it’s casing so that it is just the screen panel, the circuitry and the on/off/setting button panel remaining – completely strip the monitors?

How then do you manage the situation of switching the panels on and off when they are buried deep in the MIP – solder an extension onto the original switch and assign it to an unused button somewhere ??

Clearly I don’t want to be reaching inside the MIP every time I need to switch on and off 3 or possibly 4 panels?

Thanks for any guidance on this.

fordgt40
08-06-2012, 05:28 PM
Hi Folks,
Am I correct in thinking that you remove the actual LCD panel completely from it’s casing so that it is just the screen panel, the circuitry and the on/off/setting button panel remaining – completely strip the monitors?


Yes, though you can leave them in the frames, but they will then be "pushed back" from the screen bezels and you may not be able to access the screen controls.

On my setup, I removed all of the monitor framing, resited the "control button strip" to the top of the monitor framing using a glue gun. The monitors are all set to power on and then all wired to a single power on/off switch. If you have I/O cards then you could use an output to drive a relay and then be able to turn them all on/off using an used switch on your sim

David

Sean Nixon
08-07-2012, 02:00 AM
Or use one of those power saving adaptors that switches off all the socket outlets when it senses the master one is not pulling a load?

Goldmember
08-12-2012, 07:00 AM
My monitors remember their on/off setting when I switch the 220V from the power cable. My whole sim is powered on by one main switch and I never have to touch the monitors. Maybe it's good to check how your monitors behave before you buy them.