Goldmember
12-28-2011, 05:43 PM
Hi all, Robert and I are stuck with the measurements of the yoke, seat and pedals. Robert acted as a guinea pig for the picture (we tossed about it).
6003
The control column is 800mm, we found it in various sources like Markus Pilot. The height of the seat is 540mm, the only source for that are 777 drawings from http://www.project777.com/iddb/archiv562/61_archiv562_10563.pdf. We assume the seats are the same.
- Seat
We don't look to the edge of the glare wing but way over it. Also the lower arm slopes downwards instead of horizontal. Don't be distracted by the 'side wall', we randomly put a panel on the side. The seat must be lower than 540 mm. When we take another seat of 450mm, it seems better. On the other hand, the seat can move a lot in height (http://www.youtube.com/watch?v=AyMe1J71-CU) so what is "the" height?
- Control column
We already found out it's too close to the MIP so we should move it back 50mm. But still the yoke is nearly on our knees with the heels on the glide pad of the pedal box. The distance to the top of the glare wing also seems too much. We assume the Engravity MIP and glare wing is ok. We think our control column is too low.
Compare it with some vidcaps we took from a real cockpit video (http://www.youtube.com/watch?v=KCAW1sfF1Q8):
6004
6005
The pilots differ in body height but in both cases they keep their lower arms horizontal, they look at the edge of the glare wing and the yoke is higher (compared to the top of the glare wing).
What do we do wrong?
6006
6003
The control column is 800mm, we found it in various sources like Markus Pilot. The height of the seat is 540mm, the only source for that are 777 drawings from http://www.project777.com/iddb/archiv562/61_archiv562_10563.pdf. We assume the seats are the same.
- Seat
We don't look to the edge of the glare wing but way over it. Also the lower arm slopes downwards instead of horizontal. Don't be distracted by the 'side wall', we randomly put a panel on the side. The seat must be lower than 540 mm. When we take another seat of 450mm, it seems better. On the other hand, the seat can move a lot in height (http://www.youtube.com/watch?v=AyMe1J71-CU) so what is "the" height?
- Control column
We already found out it's too close to the MIP so we should move it back 50mm. But still the yoke is nearly on our knees with the heels on the glide pad of the pedal box. The distance to the top of the glare wing also seems too much. We assume the Engravity MIP and glare wing is ok. We think our control column is too low.
Compare it with some vidcaps we took from a real cockpit video (http://www.youtube.com/watch?v=KCAW1sfF1Q8):
6004
6005
The pilots differ in body height but in both cases they keep their lower arms horizontal, they look at the edge of the glare wing and the yoke is higher (compared to the top of the glare wing).
What do we do wrong?
6006