About to start building

[editusername]

Hello!

I got overhead light switch panel prints, what would be the best way to fit them on each other precisely and stick them between two sheets of plexiglass?

Also, should I sand the plexi behind mask for light to spread, and what thickness of it I need for back and front?

Image of the prints:
http://s529.photobucket.com/albums/dd331/cnopicilin/?action=view&current=IMG_1718.jpg

Thanks!

[editusername]

Anyone knows something useful?

[super2277]

you can use in front 1mm plexiglass and 3mm plexiglass in the back :)

[mefiu]

should I sand the plexi behind mask for light to spread
'Sand the plexi' could do, but better is to use a milk plexiglass. It spreads the light more evenly.
I hope you succeed with your idea, but something tells me sooner or latter you'd end up with engraved panels.
This print-and-glue-the-panel method rarely gives nice and fine results.

[editusername]

How much do they cost? I've seen quite many succesfull panels made with plexi and prints.