ke6jzs
04-02-2011, 02:28 PM
Hello, has anyone expercienced this.
I have a 180 degree servo, but when I use FS2Phidget it uses it as a 90 degree servo.
In the Phidget control panel it sees it as a HITEC_HS322HD and operates it as 180 degrees.
Am I suppose to tell FS2Phidget it is a HITEC_HS322HD servo?
Is there an attribute in FS2Phidget that makes it act as a 180 degree servo? Maybe in the DIVIDE section? I have played with that and the most I can get id 90 degrees.
If the servo was just a 90 degree servo than why would the Phidget control panel software operate it as a 1800 degree servo....
I have converted a Bell 212 Fuel Gauge to servo, that what I working on.
Thanks, Gary
K E 6 J Z S Barstow
I have a 180 degree servo, but when I use FS2Phidget it uses it as a 90 degree servo.
In the Phidget control panel it sees it as a HITEC_HS322HD and operates it as 180 degrees.
Am I suppose to tell FS2Phidget it is a HITEC_HS322HD servo?
Is there an attribute in FS2Phidget that makes it act as a 180 degree servo? Maybe in the DIVIDE section? I have played with that and the most I can get id 90 degrees.
If the servo was just a 90 degree servo than why would the Phidget control panel software operate it as a 1800 degree servo....
I have converted a Bell 212 Fuel Gauge to servo, that what I working on.
Thanks, Gary
K E 6 J Z S Barstow