B737NG offsets

[archen]

Hi!

A thread where we can ask for offsets for the B737NG. I begin:

I've just started with my B737NG cockpit and so far I've accomplished to make the landing gear annunciators and parking brake annunciators.

I'm starting off with the centralunit of the MIP which include:
- Landing gear
- autobrakes
- spd ref
- n1 set
- autobrakes inop annunciator and a couple of more annunciators

I had no problem with landing gear and the autobrake rotary switch (offsets available through FSUIPC SDK). But now when I'm working on the SPD REF and N1 Set rotarys I can't find any offsets? FSUIPC SDK doesn't provide those offsets (as far as I know).

Anyone know how I can find these offsets?

I don't know if it matters but Im using OC's IOcards and Prosim737 software.. Planning on using PMDG 737NGX (stripped from all logics of course) when it's released.

best regards,
Anders

[caKus]

Hi Anders,

I guess N1 offset is 07FA but it seems to work only with FSUIPC4 for FSX.

Patrick

[archen]

Hi Anders,

I guess N1 offset is 07FA but it seems to work only with FSUIPC4 for FSX.

Patrick

Thanks for your reply. I don't think thats the offset I'm looking for. Im looking for the offsets that controls the N1 set viewed in the picture below:
http://personales.ya.com/micabina737/paneles/mip/autobrakes/assets/flaps24.jpg

anyone know if I can use PM offsets with Prosim737?

[yoss]

According to the Prosim manual, you probably can.

[archen]

According to the Prosim manual, you probably can.

Read the manual and it seems like I could use PM offsets.. thats great news!!

Anyone tried using PM offsets with prosim737? Is there a simple method to try it out if it works?

[ANDYSMITH]

Hi there, The "N1 SET" knob has not been implemented yet so no offsets are going to work for that.
The N1 bug value is in the standard offset list. Don't know it but it is there. But that is an FSX thing not Prosim yet.
When you look at the button config screen, the "offsets" are there for us to remotely control things from another machine. Like if you had a phidgets card and FS2Fhidgets software controlling your throttles then you could set you A/T disconnect button to an offset of your choice from FS2Fhidgets and set the same offset in the Prosim config and your button will work in Prosim as if it were connected directly.

Andy Smith