PDA

View Full Version : off set qestion??



spiro
07-21-2010, 05:18 PM
hi to all
i just got my butiful bu0836x from mr Bondnar and i am loveing it very much
i have just a littel qestion i am trying to interface my parking brake
i am using FSX,PM with the defult a321know this is what is going on

i conected 2 inputs 1 for parking brake on offset 0bc8 32767
1 for parking brake off offset 0bc8 0
in fsuipc i when to

button+switches

i ticked both boxes : select for fs control and inclued PM

then i select :offset word set

and i use the offset 0bc4 and parameter 32767 for on

i do the same for off as i move my switch once in fs the parking brake gose on
and it indicates parking brake on the ecam
once i turn it off it turns off on fs but on the ecam it stays on??
if i tun the switch to on and off again it then turns of the ecam too could this be a PM softwere problem or am i missing somthing????
kind regards

ANDYSMITH
07-21-2010, 07:01 PM
If the parkebrake is working on the first flip like it should then the problem must be with PM. Check to see if you can accually move the plane with the switch off, and the PM indicator showing brake on.

Andy

spiro
07-22-2010, 03:12 AM
Hello Andy
well i fixed it up it dose not need 2 inputs on/off with fsuipc i done it with 1 input there were it say and PM is working ok like that the only problem know isonce i turn off the parking brake and press the diff drakes on my pedales SAITEK in the bottem left corner there is a red tab (BRAKES)
that turn on and done not turn off i calibrated the peda;les with fsuipc on the calibration page but nothing changed!!!!!!!!!
also even that there ithe tab (BRAKES)the aircraft rolls ok it dose not brake and the pedales left and right do brake ok
what could that be and can i fix this????/

kind regards