PDA

View Full Version : Any body with knowledge of gauges in FSX



737NUT
01-08-2010, 02:16 PM
I'm trying to figure if it is possible to read into a CAB file with-in a panel folder to get the current state of a switch. Example, CS727 has a Autopilot CAB/gauge, when i mouse click on the AP in the sim there has to be a state change in the software that recognizes this. It has to be for FSX to communicate and interact with the add-on plane. Thats is what i need to read in order to activate my APD llights in my sim. Is it possible to read these or is it thru offsets only. Hope it makes sense???

iwik
01-08-2010, 02:37 PM
Hi,
Fsuipc has a module called FSinterogate.You could use this to see if there is an offset.Or u could use the mouse macro in Fsuipc.If the click spot is accessible then a button can be assigned to this mouse click to operate what you want.hope this helps.
Les

737NUT
01-08-2010, 02:52 PM
I forgot about the mouse macro facility in fsuipc. I'll investigate into that. Thanks.

737NUT
01-10-2010, 05:15 PM
Well i tried Mouse Marco's with fsuipc, no go. Couldn't control them i think because it is a VC only and no 2d pnls. Back to the drawing board.