Pfd - nd

[paoloj]

Hello,

I have GC PM, and ND panel, sometimes it is showed all complete circle (360°), sometimes it is showed only upper, i must set any config ?

Thank you.

[Jackpilot]

What do you mean exactly?

[JBaymore]

I think that you are needing to switch from "Rose" (circle) to "Arc" (half circle) modes on the EFIS to change these displays. I use Ellie Avionics Systems glass so I don't know the PM setup....but if you have it hardwired to the EFIS panel.... look for Arc and Rose mode there.

best,

................john

[Jackpilot]

In that case toggle the key "C" (US keyboard)