View Full Version : PM N1 Set and SPD Ref Functions.

Joe Lavery
06-13-2009, 05:30 AM
Hi All,

Does anyone know if the N1 Set and SPD Ref rotaries on the AutoBrake panel are supported by PM?

I've found 2 offsets that seem appropriate:

5508 737 Speed Ref
550A 737 N1 Ref Select

However, like many other offsets they don't seem to do anything. I presume some coding in the logic files is needed!

Any help would be appreciated.


Joe Lavery

Trevor Hale
06-14-2009, 12:22 AM
May I suggest you send a PM to Thomas Richter through our site. Like I had mentioned before, Those offsets are reserved but nothing in PM sets them, or unsets them, however If I am not mistaken Thomas Richter's software TSR does this.


Joe Lavery
06-14-2009, 03:10 AM
Thanks again Trev,

I've done as you suggested, I'll see what Thomas has to say.