737NG Pedestal Dims [Archive]

RadarBob

06-06-2009, 07:19 AM

Hi folks,

Working on a design for 737NG Pedestal at the moment. I have dimensions of
485mm L,400mm/435mm H and 455mm W. However, on the photos I have seen, it looks as if the width reduces from top to bottom with the bottom dimension being about 50mm narrower ?

I would be grateful if anybody could confirm this.

Thanks

Rob

riche543

06-06-2009, 08:06 AM

Hey Rob Not sure if this pic helps you. Cheers Good luck.. Riche.

RadarBob

06-06-2009, 09:34 AM

Hi Riche,

Many thanks for the reply - I have that drawing actually, and if the 80mm radius starts from the edge of the panel, then the two 80's plus the 260 in the centre would make 420 leaving a 35mm reduction in width.

However, it looks a bit more than that to me, so I suspect that the radius does not start from the edge, but is set in a bit, but I'm not sure how much.

Cheers,

Rob

riche543

06-07-2009, 12:00 AM

Try this , This guy or guys are unreal what there building.. http://www.737ngproject.be/NAV.htm

RadarBob

06-07-2009, 11:18 AM

Hi Riche,

Many thanks for reminding me about this site. I have seen it before, and it is an excellent reference both for quality of workmanship and documentation of the build processes.

However, the dimension I need for the width at floor level is not given here either.

I may get the opportunity to take the measurements myself at some point soon - But failing that, I guess I'll just experiment, and go with whatever looks right against the photos.

Cheers,

Rob