View Full Version : 737 CDU - angle needed

11-16-2006, 11:10 PM
I now have my 2 new babies ... i.e. 2 engravity CDU's and about to start building the CDU stand. One dimension I'm missing is the angle of the CDU keypad to the floor (i.e to the horizontal). I think I've figured it out from height measurements but I want to be axactly sure before I start cutting.


Michael Carter
11-17-2006, 11:24 PM
Try here: http://www.markuspilot.com/MarkusPilot.htm

If the height dimensions are correct, then so will the angle.

11-18-2006, 04:41 AM
Thanks - I have those drawings but just wanted a second source to be sure. Anyhow I went with those heights and the angle that results is 30 degrees.

Michael Carter
11-18-2006, 12:07 PM
Judging from photographs, that seems about right.