Panel to switch's

[roblockett]

Hi all i'm after a bit of help (again):D

I'm wondering how i can set up rotary switch's, I'm using the Tin Mouse 737-200 and have started building the auto pilot panel, This is the problem, the panel on the aircraft use's 2 click zones to turn the A/P switch using the mouse - left and + right if i want to convert this into a real switch which has 4 zone's HDG, LOC ,AUTO APP, MANUAL G/S ( Left to Right) how would i do this? i've got a Reg FSUIPC and have got toggle switch down to a tee :D
i've had a look through the forums and can't find anything.


Thanks all

Rob

[Michael Carter]

Only assign a function in FSUIPC when the switch closes. Do not assign a parameter when the switch is released.

Use a four position rotary switch.

[roblockett]

Thanks michael, The bit i'm confused about is how to assign the possition of the switch if the panel only has a + and - mouse click spot to turn it left and right

[Michael Carter]

Forget about the on screen panel and look for the selections within FSUIPC you want to use with the switch. They're all there.

If the Tin Mouse 737-200 will not recognise the commands then use the mouse capture function within FSUIPC.

Most freeware with operate using the assignment feature, but there could be exceptions. The SP-50 in the DF727 will not recognise the AIL HOLD command, but the mouse capture function works it perfectly.

[roblockett]

Once again a star thanks mate i'll have a go later and probley still pull my hair out:D