rottenlungs
03-21-2009, 07:22 AM
Hi all
I received my new card from Leo last week and one of my first projects is to rewire my ch pedals using three of the analogue axes. I have already built a quick & dirty mcp panel (5 rotaries and 5 pushbuttons) which works like a charm.
Question: are the +5 and GND common to all the analogue inputs? I wired it up assuming this to be the case and it only seems to show one axis.
I combined the +5 and GND connections to each of the three pots so I only needed to run 5 wires from the ch pedals to the BU0836x board, +5, GND and the three signal wires.
What I`m not sure of is whether the axes aren`t working because 1) I should wire each pot completely independently to the BU0836x, 2) the pot ranges on the CH brake pedals are not suited to the BU0836x or 3) I have simply wired it wrong and confused some connections.
Any advice gratefully received..
Thanks.
James
I received my new card from Leo last week and one of my first projects is to rewire my ch pedals using three of the analogue axes. I have already built a quick & dirty mcp panel (5 rotaries and 5 pushbuttons) which works like a charm.
Question: are the +5 and GND common to all the analogue inputs? I wired it up assuming this to be the case and it only seems to show one axis.
I combined the +5 and GND connections to each of the three pots so I only needed to run 5 wires from the ch pedals to the BU0836x board, +5, GND and the three signal wires.
What I`m not sure of is whether the axes aren`t working because 1) I should wire each pot completely independently to the BU0836x, 2) the pot ranges on the CH brake pedals are not suited to the BU0836x or 3) I have simply wired it wrong and confused some connections.
Any advice gratefully received..
Thanks.
James