FSUIPC Flap Settings?

[Geremy Britton]

i am using voice buddy and it requires a key to programme each flap setting. On the fsuipc page under keys i find flaps and the options are:

flaps 1
flaps 2
flaps 3
flaps increments
flaps down

but i need to programme keys to flaps 5, 10, 15, 20, 25 and 30.

any ideas how i could do this- i am baffled?:-(

also i cannot find; exits open/ close either. i have looked under doors, etc, no joy

If someone could give me some pointers on this i would be grateful.

Thanks again, Geremy

[Michael Carter]

You have to have the box checked for flap increment, or flap gate positions or somethinh like that, and then program the gate settings manually. I don't have the program open so I don't know exactly what the name of that box is.

You program the gate stops by telling FSUIPC where the starting and stopping point is for each of the settings. You can program up to eight or nine positions (I think).

You can make it aircraft specific too if you like. Read the manual closely for flap programming. The GUI is a bit of a mess, but you'll figure it out.