Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie
    Join Date
    Mar 2007
    Location
    Vancouver
    Posts
    192
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Phidget 0/16/16 - how to get working

    I would have read the instructions if there were any, but I cannot get the Phidget 0/16/16 working. In the brief instruction sheet, it says you have to apply power to an input, but do I have to apply a power source to EACH digital input to get it working? How do I power the 16 outputs?

    Perhaps I'm missing something, but I'm a little disappointed that this unit is hardly plug and play. I get the mini LEDs built onto the board working using FS2Phidget, but how do I power an LED on the same output? And I see there's loads of 'G' connectors, but no guidance on what these are (assuming electrical Ground) and don't you just need one? There's certainly NOT one per input/output.

    And I still haven't got the LED 64 unit working Anyone who has set one up got any circuit diagrams?

    Thanks for any help

    Paul
    VANCOUVER
    Jet fighter / single pilot sim, plus thinking of a 777 as a secondary sim.

  2. #2
    500+ This must be a daytime job
    Join Date
    Nov 2005
    Location
    rotterdam, the Netherlands, Europe
    Posts
    804
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    These schematics should come in handy.

    Explain the wiring of the phidgets.

    http://www.flyengravity.com/page/downloads/3

    Stef
    www.boeing737ng.com
    ___________________________
    The Dutch 737 Simulator Project

  3. Thanks Andre V thanked for this post
  4. #3
    150+ Forum Groupie
    Join Date
    Mar 2007
    Location
    Vancouver
    Posts
    192
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks Stef - I took a look and found some very very useful information. This has also answered several other questions, not least how to put an old computer power supply to some good use
    VANCOUVER
    Jet fighter / single pilot sim, plus thinking of a 777 as a secondary sim.

Similar Threads

  1. Replies: 11
    Last Post: 02-28-2011, 04:09 PM
  2. Argh 3 phidget boards nicht working with FS2PHIDGET
    By Paul G in forum FS2Phidget Releases
    Replies: 2
    Last Post: 09-10-2008, 02:50 PM
  3. Phidget 64 LED not working
    By Paul G in forum FS2Phidget Users
    Replies: 4
    Last Post: 05-30-2007, 02:56 PM
  4. LED 64 Phidget
    By wchambers in forum Phidgets & Cockpit Simulator Builder
    Replies: 1
    Last Post: 11-09-2004, 09:51 PM
  5. 8/8/8 phidget help
    By imported_737nut in forum Phidgets & Cockpit Simulator Builder
    Replies: 4
    Last Post: 11-03-2004, 06:00 PM