Results 1 to 3 of 3

Thread: Interfacing

  1. #1
    25+ Posting Member
    Join Date
    Mar 2007
    Location
    Sweden
    Posts
    35
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Interfacing

    To start with I just want to say hello to you all,I have been building on my 737ng project for 2 yrs with a short break(6 month) when I joined swedish army and went down to Kosovo as a Fn-soldier(did it to earn money so I could buy new products for my cockpit).

    Ok now for the question.

    I have the FDS SYS3 card for my MIP, a few days ago I orderd a complete built TQ from simparts with Phidgets interfacing, am wondering if it`s possible to use Phidgets cards just for the TQ and the SYS3 for the MIP, or will the cards software counteract each other?

    Am a really newbie with interfacing.

    Regards
    What goes up, must come down, one way or the other.

    Safe landings

    Martin
    http://www.freewebs.com/boeing737ng/

  2. #2
    1000+ Poster - Fantastic Contributor Bob Reed's Avatar
    Join Date
    Oct 2005
    Location
    Holley, New York U.S.A.
    Posts
    1,880
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Should not be a problem. I have used multiple interfaces in the past without too much trouble. Probably take a bit of setup.
    Bob Reed

  3. #3
    25+ Posting Member
    Join Date
    Mar 2007
    Location
    Sweden
    Posts
    35
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanx Bob,good to hear that I don`t have to switch the entire setup to Phidgets.

    Regards
    What goes up, must come down, one way or the other.

    Safe landings

    Martin
    http://www.freewebs.com/boeing737ng/

Similar Threads

  1. Opinion on TV interfacing
    By gokhotit in forum Pilots Lounge - Let your Hair down
    Replies: 3
    Last Post: 05-04-2010, 11:02 AM
  2. I/O Interfacing
    By jhaverkamp in forum I/O Interfacing and Hardware
    Replies: 3
    Last Post: 12-23-2009, 02:44 PM
  3. I/O & software interfacing
    By jhaverkamp in forum Welcome to MyCockpit New here? Introduce Yourself!
    Replies: 0
    Last Post: 12-07-2009, 11:31 AM
  4. Fmc Interfacing...
    By dodiano in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 03-03-2008, 06:27 PM
  5. Interfacing Flash and FSX?
    By Paul G in forum I/O Interfacing Hardware and Software
    Replies: 2
    Last Post: 02-26-2008, 12:53 AM