Results 1 to 2 of 2

Thread: Apu startup

  1. #1
    John Hansen
    Guest

    Apu startup

    Hi There....

    I have seen the video from Flightillusion / project Magenta
    about overheadpanel.( GSA-OVH )...I notist that the APU
    after start passes 400 degrees very quckly and the apu already is online

    I can verify that is too quickly...I have starter a real
    Boeing 737-800 as ref.

    My question : is it possible to change things like that
    or is it programmed by PM.
    PM as i see it should simulate the real thing....

    Regards John Hansen, Denmark


  2. #2
    Thomas Richter
    Guest

    Re: Apu startup

    Yes, it is controlled by:

    [Consts]

    system = 7377
    apuNspooltime=12
    apuEGTspooltime=15
    apuegttarget = 680
    apuspooltime = 10

    --
    Best Regards
    Thomas Richter

    "John Hansen" schrieb im Newsbeitrag
    news:411402.82117@wb.onvix.com...
    > Hi There....
    >
    > I have seen the video from Flightillusion / project Magenta
    > about overheadpanel.( GSA-OVH )...I notist that the APU
    > after start passes 400 degrees very quckly and the apu already is online
    >
    > I can verify that is too quickly...I have starter a real
    > Boeing 737-800 as ref.
    >
    > My question : is it possible to change things like that
    > or is it programmed by PM.
    > PM as i see it should simulate the real thing....
    >
    > Regards John Hansen, Denmark
    >



Similar Threads

  1. GC Startup
    By vybhav in forum PM Boeing GC
    Replies: 2
    Last Post: 04-07-2010, 11:42 PM
  2. As a good startup
    By Spatate in forum Where to Start Building a Home Cockpit
    Replies: 2
    Last Post: 02-04-2009, 04:51 PM
  3. Pmsystem startup
    By mmakela in forum PMSystems
    Replies: 0
    Last Post: 12-22-2008, 11:23 AM
  4. Apu startup
    By John Hansen in forum PM General Q & A
    Replies: 1
    Last Post: 02-12-2007, 09:38 PM
  5. Startup problems..
    By Tom Stian Bjerk in forum PM General Q & A
    Replies: 2
    Last Post: 01-29-2006, 05:53 PM