Results 1 to 3 of 3
  1. #1
    Enrico Schiratti
    Guest

    Re: frame and data rates decreasing in recent GC versions

    Hi Tomek,

    I did a couple of tests, with, without FMC and MCP... comparing framerates
    with 437 and 430.

    Once all loading is done (and that is important, because when the programs
    start up, and they start up differently in recent versions) the framerate
    is
    nearly identical. I waited until the overview page on the ND came and went.
    (Ctrl-O)

    From your screenshots it seems you were not even using the MCP for the
    tests.

    In any case, I copied the folder and ran the 0 and the 7 with the same INI
    settings... as you can see, I managed to make a screenshot of the 430
    running at 50% of the full framerate once it is loaded. (they have been
    resized to 800 pixel width).

    I have to point out though, framerate, once aboce the data rate, is
    irrelevant... what matters is the regularity of the data coming through.

    Thus on this and another computer I can't see the difference in framerates
    you see, and I simply wouldn't know what is causing it on your system.

    Ciao

    Enrico

  2. #2
    Enrico Schiratti
    Guest

    Re: frame and data rates decreasing in recent GC versions

    F1 page

  3. #3
    Tomek T.
    Guest

    Re: frame and data rates decreasing in recent GC versions

    Hi Enrico!
    Thank You!
    I will check our system and if I will recover problem, I will write about
    it.
    Regards!


Similar Threads

  1. frame rates
    By airsideservicesltd. in forum Cockpit Outside Visualization
    Replies: 2
    Last Post: 02-01-2008, 07:59 PM
  2. Frame Rates
    By Patrick Smith in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 07-08-2007, 02:57 PM
  3. Re: frame and data rates decreasing in recent GC versions
    By Enrico Schiratti in forum PM General Q & A
    Replies: 1
    Last Post: 02-12-2007, 10:12 AM
  4. frame and data rates decreasing in recent GC versions
    By Michal Buciak in forum PM General Q & A
    Replies: 9
    Last Post: 04-14-2006, 12:22 PM