RUNTIME ERROR issue

[lineman55]

Yes Alan they do work...when all is ok.

[alandyer]

James,

Could you monitor mem usage for fs2phidget.exe and fs2004.exe ?
May eliminate memory as an issue.

Regards,
Alan.

[lineman55]

Are you asking for memory usage figures when both are running together?
PC INFO/ I have 1gig memory/ram DDR ,939socket MB /AMD64
I will monitor usage and report back this weekend....sometime inbetween work

Thanks Alan

[alandyer]

Yes, when both a running together.
As you would normally run.

[alandyer]

James,

Zip up your ini files in both folders.
email zipped files to lineman55@coconutair.com

Want to test using your configuration.

When you checked mem usage was that right up to freeze ?

Regards,
Alan.

[lineman55]

Yes Alan.
I tooK a flight last night and flew around trying to catch what might cause this error to happen and it lasted a good 45min until I applied the speed brakes fully and thats when it crashed with the ERROR 0 .
I doubt that really caused it...mabe my timimg was coincidental on that .
here is what I read for the memory usage
FSPHIDGETS 2,888
FS9 334,224 cpu 100%
PM MCP 13,224
When the error occured Phidgets no longer appeared in the memory window.
No reading available to report.
I id find that my throttle 1 was not active/enabled when I first started Phidgets.
I do check all 3 boards prior to flight in the program to make sure all are enabled that should be and have found a few that do not enable when started.
THROTTLE 1 (newest found not enabled)
OUTER MARKER...(been ok lately)
FLAPS ...(needed recalibrating a few times but ok)

I will send you the the ini files .
Kind regards
James

[alandyer]

James,

You're also running PM MCP on same machine ?

Alan.

[lineman55]

Yes I am,
All three on this machine.Handles it very well I must say.I did have the PM MCP
on one of my clients but it created problems and found this to be the solution that never had problems .I have been running it for 2 yrs.

Remember Alan that I had to upgrade to XP SP2 to install your update?
Just a reminder.... Never had the errors until now.
Did you need anymore info?

Regards
James

[alandyer]

James,

Actually is really YOUR update.
Most of this stuff I do is for benefit of you guys out there.
I ask these questions so I can diagnose problem.

Regards,
Alan.

[lineman55]

Your right,
I stand corrected...
Just trying to stay updated to benefit from the excellent features now available


Regards
James