Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Feb 2005
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    lights whit more values

    How can i make a led go on, on particular values.

    The flap extende has to go on when the flaps have reached there positions up to flap ten. Flap transit has to go on when the flaps are in transit until it has reached flap ten after that the flaps extended stay's on and the flaps transit stay off.

    How can i tell phidgets in the offsets to do this???

    Also i have the offsets for the below / glide slope but it doesn't work.

    regards,

    Martijn Schoot

  2. #2
    alandyer
    Guest
    Martjin,

    Groete. How gaan dit?

    Have a look at 'Below Glidescope Annunciator' thread.
    James asked same question and there is perhaps a solution for you posted there.
    James het die selde gevra. Miskien is daar 'n antwoordjie vir jou daar binne.

    Alan.

Similar Threads

  1. Nav lights Taxi lights
    By mocha22 in forum General Aviation (GA) Builder Disccusion
    Replies: 2
    Last Post: 03-04-2011, 08:35 AM
  2. Problem whit throttle unit
    By giosue in forum Computer Hardware Setup
    Replies: 1
    Last Post: 04-09-2009, 12:22 PM
  3. Problem whit throttle unit
    By giosue in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 03-18-2009, 01:12 PM
  4. Low values for N1 and N2, and thanks.
    By RobertoR in forum FS2Phidget Users
    Replies: 2
    Last Post: 02-03-2005, 02:38 PM