Thread: Flap needle alignment
12-12-2004, 05:23 PM #1SkydvdanGuest
Flap needle alignment
I was wondering if anyone here could help me get my flap gauge to indicate correctly using the servo phidget. I thought that I had read something on this site that talked about getting the needle to move to the correct position on the gauge face. Right now I am still using the keyboard to move the flaps to the various detents so bear with me on this one. Starting with the flaps up I hit the F7 key to move the flaps to the first detent and the needle moves to 2%. BTW my flap gauge reads from 0 to 100% (C-130 flap gauge, it reads in percent not degrees.) The second tme I hit F7 the needle moves to about 18%. The third hit moves it to about 42%. The fourth hit of F7 moves the needle to 100%. Ideally instead of 2, 18, 42 and 100% it should move 10, 20, 50 and 100%. So how do I get it to move to the new positions? Is it in the aircraft.cfg or a function of fs2phidgets.ini or something completely different? Can someone please point me in the right direction?
12-13-2004, 11:19 PM #2alandyerGuest
Let me have FSValues for each of yor flap settings.
12-14-2004, 12:05 PM #3SkydvdanGuest
The FS Values are:
Thanks in advance,
By wledzian in forum Cockpit Outside VisualizationReplies: 9Last Post: 05-30-2013, 02:50 AM
By mmakela in forum Dodiano's Airbus ForumReplies: 1Last Post: 04-12-2009, 08:42 AM
By t1dUs in forum Cockpit Outside VisualizationReplies: 4Last Post: 03-17-2009, 07:41 PM
By imported_sweker in forum FS2Phidget UsersReplies: 7Last Post: 01-08-2007, 02:09 PM
By Peter Parnreiter in forum PM General Q & AReplies: 4Last Post: 01-08-2006, 07:54 AM