Results 1 to 6 of 6
  1. #1
    imported_MattO
    Guest

    V2.0.8 - SideStick and Rudder not Able to Center

    With V2.0.8 installed, after making sure the SideStick/Rudder are calibrated (center being 500), MSFS was showing the rudder being about 30% Left off of the center line (100% being full deflection). and the aileron, about 30% left and Elevator 30% up.

    Matt O.

  2. #2
    imported_MattO
    Guest
    I just figured something out.....

    The Control surfaces analogs are going from 0-16xxx, rather the -16xxx to +16xxx, I think, like prior to Ver 2?

    I think "9" will be a lucky number

    Matt O.

  3. #3
    alandyer
    Guest
    MattO,

    I had smae problem with analog inputs.
    You picked up problem about same time I did.

    2.0.9 wiil fix that.
    Hopefully, I'll also have servos smoothed out.
    Between David and his trusty oscilloscope we may have a solution.
    Will release 2.0.9 later this evening or tomorrow during day (Central time)

    Alan.

  4. #4
    Nav Lt
    Guest
    Alan,

    May I ask what it is that you are trying to smooth out on the servos? It wouldn't be perhaps dealing with making FSphidgets work with 360 degree servos would it?

    Yes I'm still tinkering with trying to make my flaps indicator operate in the 270 degree range like the real 737NG MIP. I know, I know, I should just buy a 180 degree servo, but i'm just super pickey.

    Regards,
    James Twomey

  5. #5
    alandyer
    Guest
    Nope.
    One thing to consider might be to add gearing to servo.
    Ratio of about 2:3 should do it.
    There are few places that sell smallish nylon gears over internet.

  6. #6
    alandyer
    Guest
    MattO,

    Problem with analogs should be sorted out with 2.0.9.
    Available for download.

    Alan.

Similar Threads

  1. Airbus sidestick.
    By Scandinavian-A330 in forum General Builder Questions All Aircraft Types
    Replies: 10
    Last Post: 07-04-2016, 02:55 PM
  2. Sidestick?
    By Atomic_Sheep in forum Airbus Discussion
    Replies: 4
    Last Post: 12-12-2010, 06:41 AM
  3. Rudder Trim - Does it physically move the center of the rudder?
    By Ronson2k9 in forum General Aviation (GA) Builder Disccusion
    Replies: 6
    Last Post: 09-30-2010, 07:00 PM
  4. Optimizing Windows XP Media Center Edition 2005 and Media Center Extender Networks
    By MS Expert Zone RSS Feed in forum Computer Hardware Setup
    Replies: 0
    Last Post: 12-28-2006, 10:30 AM
  5. Optimizing Windows XP Media Center Edition 2005, Xbox 360, and Media Center Extender
    By MS Expert Zone RSS Feed in forum Computer Hardware Setup
    Replies: 0
    Last Post: 12-28-2006, 10:30 AM