Results 1 to 4 of 4

Thread: V/s Help Please

  1. #1
    imported_MattO
    Guest

    V/s Help Please

    Alan, anybody else, HELP.........

    This is driving me nuts... and no help from PM

    Got everything else working on the MCP/FCU but the V/S.

    ----------------
    After hours of playing around, I found out when I turn the Encoder, and as the FSValue increase, and reaches 50 the V/S changes to 0100 (there is no change in the V/S, it stays at 0000 untill it reaches 50), then as I continue to turn and the FSValue increases to 150 the V/S changes to 0200.

    50=100
    150=200
    250=300
    350=400
    and so on.....

    ----------------------------
    In the FS2PhUIPC.INI file

    [FCU_V/S_SET]
    Offset=540C
    Length=2

    I've tried Mulitpliers, divisors.... got now where..... help :confused:

    Matt O.

  2. #2
    imported_MattO
    Guest
    ADDITION

    With Version 2.0.8
    Now when I read the V/S I get the FSValue displayed in the TXT LCD. Does this mean I need to enter a divisor?

    Matt O.

    ;
    ;PM_Airbus_FCU
    ;
    ;FCU_READ
    ;
    [FCU_READ_ALTITUDE]
    Offset=04E4
    Length=4
    Multiplier=100
    Format=#####
    [FCU_READ_HEADING]
    Offset=4E2
    Length=3
    Format=###
    [FCU_READ_VERTICLE_SPEED]
    Offset=04E6
    Length=3
    Format=###
    [FCU_READ_IAS]
    Offset=4E0
    Length=3
    Format=###
    [FCU_READ_MACH]
    Offset=4E8
    Length=3
    Format=###
    ;
    ;FCU_SET
    ;
    [FCU_SET_IAS]
    Offset=5406
    Length=2
    [FCU_SET_HEADING]
    Offset=5408
    Length=2
    [FCU_SET_ALTITUDE]
    Offset=540A
    Length=2
    [FCU_SET_VERTICLE_SPEED]
    Offset=540C
    Length=2
    [FCU_SET_MACH]
    Offset=540E
    Length=2

  3. #3
    alandyer
    Guest
    Matt,

    Will not be able to emulate your set-up for a few days.
    Have to re-arrange my PCs, software and/or hardware to do this.
    I am releasing 2.0.9 a little later this evening.

    This release addresses servo smoothness and sound.

    But, FCU V/S may work with new version
    by adding setting
    Step=100

    Regards,
    Alan.

  4. #4
    imported_MattO
    Guest
    Good news!!!

    FS2Phidget V2.0.9 with the STEP setting at 100 fixed the problem.

    [FCU_V/S_SET]
    Offset=540C
    Length=2
    Step=100

    Regards,
    Matt O.


    SUCCESS!!!!!!! AtaBoy Alan, four pats on the back