V/s Help Please
Alan, anybody else, HELP.........
This is driving me nuts... and no help from PM
Got everything else working on the MCP/FCU but the V/S.
After hours of playing around, I found out when I turn the Encoder, and as the FSValue increase, and reaches 50 the V/S changes to 0100 (there is no change in the V/S, it stays at 0000 untill it reaches 50), then as I continue to turn and the FSValue increases to 150 the V/S changes to 0200.
and so on.....
In the FS2PhUIPC.INI file
I've tried Mulitpliers, divisors.... got now where..... help :confused:
With Version 2.0.8
Now when I read the V/S I get the FSValue displayed in the TXT LCD. Does this mean I need to enter a divisor?
Will not be able to emulate your set-up for a few days.
Have to re-arrange my PCs, software and/or hardware to do this.
I am releasing 2.0.9 a little later this evening.
This release addresses servo smoothness and sound.
But, FCU V/S may work with new version
by adding setting
FS2Phidget V2.0.9 with the STEP setting at 100 fixed the problem.
SUCCESS!!!!!!! AtaBoy Alan, four pats on the back