Annonciators

[liam mockler]

Just wondering if it is possible to hook up some annunciators using PM.
"Speed Brake extended, LE flaps extended, Antiskid Inop, Autobrake Disarm,
Speed Brake Armed, Speed Brake Do not arm" are the annonciators that i can't
find any codes for Project Majenta.

Also wondering if it's possible to hook up the 3 buttons A/P P/RST, A/T P/RST
and FMC P/RST buttons.

I am buiding the sig MIP from flight deck solutions. Any help would be
greatly appreciated.

[Kester Meijer]

For this purpose I will use the MIP737 interface board of CP Flight. You do
need the CP Flight MCP to daisy-chain the MIP board.
http://www.cpflight.com/sito/dettagli/mip.asp

I have not yet found any way to do it direct from Phidgets, but the MIP board
solved that for me. With this it is plug and play, no offset programming
required as it ties into PM directly.

Kester Meijer
http://www.ifsbi.org - for cockpit builders information
http://fly.ekezz.com - to see my cockpit construction

[Enrico Schiratti]

Note... 407 (and later ones) is the build you want for the MIP... it is now

on www.projectmagenta.com/latest.html

Ciao

Enrico

"Kester Meijer" wrote in message
news:408385.81494@wb.onvix.com...
> For this purpose I will use the MIP737 interface board of CP Flight. You
> do
> need the CP Flight MCP to daisy-chain the MIP board.
> http://www.cpflight.com/sito/dettagli/mip.asp
>
> I have not yet found any way to do it direct from Phidgets, but the MIP
> board
> solved that for me. With this it is plug and play, no offset programming
> required as it ties into PM directly.
>
> Kester Meijer
> http://www.ifsbi.org - for cockpit builders information
> http://fly.ekezz.com - to see my cockpit construction
>

[Delphi]

Hi Folks,
is there a way to interface those buttons without the the MIP737 board from CP?

Thanks for your answer!

Best regards,
Ruediger

[Bob Reed]

Well you will need some sort of interface. Do you have one?

[Delphi]

I use IO Cards from Opencockpits. I'm very familiar with interfacing. The problem is that I can not find the offsets in PM. I have PM GS, MCP, CDU and PMSystems.

Would be great to get help from you.

Best Regards,
Ruediger

[Hans Krohn]

Check pm-systems:

Build 97

- small changes to menu system
- MasterLightTest can be used for DO and LE outputs, adding 'NLT' will disable it for any given output

Hans