Results 1 to 3 of 3
  1. #1
    Thomas Richter
    Guest

    TCAS on pm`s ND with FSInn solved!!

    Hi all,
    after some long nights and a very hard job for my Harddisks (they must be
    very hot and much older than before) FSInn for VATSIM is now working together
    with FS2004 (and so with PM`s ND and QuickMap).
    We need a special configuration on min. 2 PC`s, latest AiBridge (3.0) and a
    procedure to go online.
    1. PC-1 FS2004:
    1.1. FSInn-Control Panel: running with FS-Start
    1.2. AiBridge 3.0: starting when FSInn is started on PC-2 but NOT ONLINE (to
    VATSIM)

    2. PC-2:
    2.1. FSInn (Panel)
    2.2. Connect Framework (FSInn), this program has to be run NOT ON FS2004-PC
    together with AiBridge (AiBridge will crash)
    To go online FS is running:
    1. Start FSInn on PC-2
    2. FS shows message that FSInn is now on MP
    3. Start AiBridge 3.0 on FS-PC
    4. FS shows message that AiBridge is in MP
    5. Connect FSInn (PC-2) to VATSIM
    You will see traffic in ND and QuickMap.
    If you close connection to VATSIM but FSInn and FS is still in MP-Mode, to
    connect to VATSIM you have first to start AiBridge, because it is closing by
    disconnecting FSInn to VATSIM.

    Best Regards
    Thomas Richter


  2. #2
    Enrico Schiratti
    Guest

    Re: TCAS on pm`s ND with FSInn solved!!

    That sounds quite complex, does it have to do with
    multiplayer connectivity or something like that?

    Are the programmers aware of this?

    "Thomas Richter" wrote in
    message news:385970.77380@wb.onvix.com...
    > Hi all,
    > after some long nights and a very hard job for my
    > Harddisks (they must be
    > very hot and much older than before) FSInn for VATSIM is
    > now working together
    > with FS2004 (and so with PM`s ND and QuickMap).
    > We need a special configuration on min. 2 PC`s, latest
    > AiBridge (3.0) and a
    > procedure to go online.
    > 1. PC-1 FS2004:
    > 1.1. FSInn-Control Panel: running with FS-Start
    > 1.2. AiBridge 3.0: starting when FSInn is started on PC-2
    > but NOT ONLINE (to
    > VATSIM)
    >
    > 2. PC-2:
    > 2.1. FSInn (Panel)
    > 2.2. Connect Framework (FSInn), this program has to be run
    > NOT ON FS2004-PC
    > together with AiBridge (AiBridge will crash)
    > To go online FS is running:
    > 1. Start FSInn on PC-2
    > 2. FS shows message that FSInn is now on MP
    > 3. Start AiBridge 3.0 on FS-PC
    > 4. FS shows message that AiBridge is in MP
    > 5. Connect FSInn (PC-2) to VATSIM
    > You will see traffic in ND and QuickMap.
    > If you close connection to VATSIM but FSInn and FS is
    > still in MP-Mode, to
    > connect to VATSIM you have first to start AiBridge,
    > because it is closing by
    > disconnecting FSInn to VATSIM.
    >
    > Best Regards
    > Thomas Richter
    >



  3. #3
    MANANDISE Marc
    Guest

    TCAS on pm`s ND with FSInn solved!!

    Hi Thomas and Enrico,

    Effectively, it's quite difficult to follow the explanations of Thomas.
    Thomas, do you speak about FSInn or FSCopilot for the PC 2. For AiBridge is that
    on the PC 1 or 2. You don't speak about FSCopilot anyway ? What about this
    software ?

    Many thanks for your more explanations.
    Perhaps it could be an easier solution for receiving the TCAS information in
    our ND !

    But, many thanks for your cogitations for us.

    Best Regards

    Marco


Similar Threads

  1. FSinn and an ATC-module?
    By jespergb in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 06-01-2010, 04:59 PM
  2. PFC pedals issue solved
    By Shawn in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 03-30-2010, 11:32 PM
  3. FSINN & Squawk Modes
    By riche543 in forum MyCockpit Online Flying Discussion
    Replies: 5
    Last Post: 06-12-2009, 06:10 PM
  4. Yoke Problem Solved
    By Michael Carter in forum My Cockpit Update
    Replies: 2
    Last Post: 04-25-2007, 09:56 PM