01-15-2006, 07:51 PM #1Karl BatesGuest
I have updated to the latest version of FSUIPC, however after cut & pasting
it into the folder I am still showinh Version 3.45 22nd Jan 05. I have a reg
version. Any ideas.
01-16-2006, 04:46 AM #2Enrico SchirattiGuest
>I have updated to the latest version of FSUIPC, however
>after cut & pasting
> it into the folder I am still showinh Version 3.45 22nd
> Jan 05. I have a reg
> version. Any ideas.
Did you try deleting the FSUIPC DLL, make sure it's gone and
then copy the fresh one into the Modules folder?
01-16-2006, 05:51 AM #3Karl BatesGuest
Sorry that was something that I failed to do, Doh! Have now done that and
everything is ok with the FSUIPC.
Thanks again, Karl
01-16-2006, 06:19 AM #4Enrico SchirattiGuest
Well, you do not have to do the deleting, but I just wanted
to make sure it was really the copying that failed.
You have to do it while FS is not running, in any case.
"Karl Bates" wrote in message
> Sorry that was something that I failed to do, Doh! Have
> now done that and
> everything is ok with the FSUIPC.
> Thanks again, Karl
By mocha22 in forum General Aviation (GA) Builder DisccusionReplies: 4Last Post: 04-04-2011, 02:14 AM
By spiro in forum I/O Interfacing and HardwareReplies: 2Last Post: 11-15-2009, 07:42 PM
By mounty in forum Cockpit Software: MiscellaneousReplies: 12Last Post: 05-17-2008, 04:42 AM
By visualchaosfx in forum I/O Interfacing Hardware and SoftwareReplies: 4Last Post: 02-28-2007, 05:25 PM
By Bob Reed in forum PM General Q & AReplies: 3Last Post: 03-19-2006, 11:47 AM