Results 1 to 3 of 3
  1. #1
    null null
    Guest

    Cannot run demo's, assistance please

    I have just downloaded five of the demo progs and installed them.

    The Boeing Type MCP & CDU work fine but I get the following error message
    when attempting to fire up the GA IFR, PMSystems and GC demos:

    nVidia Open GL Driver

    Driver component sizes mis-match. Return to keep going, Cancel to exit.

    Can anybody assist please?

    Thanks in advance.

    Rgds




  2. #2
    Chris Whitley
    Guest

    Cannot run demo's, assistance please

    You sure you've got the full nVidia drivers installed on the PC? I personally
    use Omegadrivers ( www.omegadrivers.net ) for all my PM machines and they
    work great.

    Cheers
    Chris


  3. #3
    Katy Pluta
    Guest

    Re: Cannot run demo's, assistance please

    On Thu, 30 Dec 2004 19:28:43 EST, Michael Potten wrote:

    > I have just downloaded five of the demo progs and installed them.
    >
    > The Boeing Type MCP & CDU work fine but I get the following error message


    > when attempting to fire up the GA IFR, PMSystems and GC demos:
    >
    > nVidia Open GL Driver
    >
    > Driver component sizes mis-match. Return to keep going, Cancel to exit.
    >
    > Can anybody assist please?
    >
    > Thanks in advance.
    >
    > Rgds


    You need to completely un-install the current video drivers then re-install
    them, which video card is it precisely?

    --
    All the Best
    Katy Pluta


Similar Threads

  1. Projector Assistance
    By vybhav in forum Projector Solutions
    Replies: 14
    Last Post: 10-04-2009, 05:47 AM
  2. DIY Simparts TQ assistance
    By diegov in forum General Builder Questions All Aircraft Types
    Replies: 3
    Last Post: 03-10-2009, 11:29 PM
  3. Need Assistance with CRJ Cockpit layout
    By TucanoRC in forum General Builder Questions All Aircraft Types
    Replies: 7
    Last Post: 07-04-2008, 01:14 PM
  4. Ntsb Investigation Assistance
    By cdjung in forum PM General Q & A
    Replies: 8
    Last Post: 02-19-2007, 04:46 AM