Results 1 to 3 of 3
  1. #1
    25+ Posting Member
    Join Date
    Oct 2014
    Location
    Germany
    Posts
    60
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Rudder Pedals finetuning?

    Hi all,
    I received my new rudder pedals. In comparison to the old saitek ones the do have a much larger movement area when you push them. I have calibrated them in FMGS. vonfig and there it looks fine. All the max values are setup and saved at each end position. Within P3D, while performing a flight the situation is different. There I get full rudder position already after half the way I can use my pedals... Is there any way to change this. Is this maybe a bug? Increasing neutral zone further is no option!
    I would be great if someone may have a solution for me.
    Thanks and best regards
    Michael

  2. #2
    150+ Forum Groupie
    Join Date
    Nov 2015
    Location
    Krefeld, GER
    Posts
    243
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Rudder Pedals finetuning?

    check, if FMGS is the only place for your config.
    Sometimes P3D is setting up new hardware automatically, even if you have had deactivated it before.

    Michal

  3. #3
    25+ Posting Member
    Join Date
    Oct 2014
    Location
    Germany
    Posts
    60
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Rudder Pedals finetuning?

    Hi Michael,
    thanks for your reply! It was exactly like you said! The new pedals have been setup in P3D and disturbed the FMGS ibstallation. Now it works fine. Thanks again and have a nice rest of the weekend.
    Cheers
    Michael