A320 FMGS B52

[asessa]

I always have a flight online with real weather but i never had this "problem" with the atc.. in any case, i setted the value to "no". thanks

[Barrykensett]

I was recently surprised that having set it to suit online flying it reset itself when I loaded an update prompting raspberry noises from ATC. Need to remember to check it after updates.
barry

[Barrykensett]

Just developed a new problem, FMGS across my network seems to fail after about one hour of flying. Most of the services in the server window show disconnected. A window pops up with following error message, can anyone suggest where to look for the problem?

Widefmgsserver
Access violation at address 00407EFO in module “ServerwideFMGS.exe” Read of address FFF4003E

[jeehell]

Just developed a new problem, FMGS across my network seems to fail after about one hour of flying. Most of the services in the server window show disconnected. A window pops up with following error message, can anyone suggest where to look for the problem?

Widefmgsserver
Access violation at address 00407EFO in module “ServerwideFMGS.exe” Read of address FFF4003E

Hi Barry

I have worked on that one, it should be better in next release.

JL

[jeehell]

Just developed a new problem, FMGS across my network seems to fail after about one hour of flying. Most of the services in the server window show disconnected. A window pops up with following error message, can anyone suggest where to look for the problem?

Widefmgsserver
Access violation at address 00407EFO in module “ServerwideFMGS.exe” Read of address FFF4003E

Hi Barry

I have worked on that one, it should be better in next release.

JL

[Barrykensett]

Thanks JL, I will break my long flights into short legs in the meantime! Restarting server seems to clear it so then put flight plan in for next leg!

[navigator88]

Hi Jeehell, Do you think in the future you could insert in the mcdu the print function in order to use a printer?
Thanks very much for your fabulous software.
Merry Christmas and happy 2020.
Ben

[jeehell]

Hello everyone,

The last release is available, updater or here:
http://www.jeehell.org/A320FMGS_B52.5.0.exe
What's new:
-Fixed many issues with networking (wideFMGS protocol)
-Switched another port to UDP for better performance and connection stability
-Fixed PROG APPR page CRZ LVL entry
-Fixed some SIOC little issues (RUDDER TRIM and FCU Speed DOT, when ANN LT TEST)
-Fixed QNH switching from inhg to mb by itself on CPT side
-Fixed many routes drawing and tracking issues
-Improved AP and FBW behavior
-Fixed some rare errors when selecting procedures in MCDU
-Fixed FWC issues when a secondary failure is displayd but then removed while going into inhibition phase
-Fixed EHID performance issues with MCDUs
-Fixed DIRTO issue when waypoint is not in FPLN ,it would keep some CSTR from an other waypoint
-Fixed some ALT CSTR issues, and added support for WINDOW ALT CSTR
-Fixed issue in sound module where the FWC whould trigger undesired RA callouts at intermediate altitudes
-Fixed DDRMI issue where needles disappeared
-Fixed go around speed target when SRS disengages


Wish you all a merry Christmas
JL

[anzabon]

A Merry Xmas and a good start into 2020 for you and your family, too! And especially a huge THANK YOU for your patient and continuing work on the improvement of your outstanding software! Stay healthy and enthusiatic! Bon

[iwik]

Thanks JL,
Merry Xmas to you.
Les