Results 1 to 2 of 2
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jul 2017
    Location
    miami
    Posts
    7
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Mycockpit.org Offsets Airbus Project magenta - help

    HiI'm trying to set up some airbus (PM) offsets where I have 12 pedestal buttons that have the same offset, but some values I can not assign.In the virtual overhead of the airbus, when we pass the mouse on the button, it already shows the offset.Example:
    ENG button - pm4F4 = 301 0x4f4 WORD Val = 0
    BLEED button - pm4F4 = 302 0x4f4 WORD Val = 0
    PRESS button - pm4F4 = 303 0x4f4 WORD Val = 0
    Boot ELEC - pm4F4 = 304 0x4f4 WORD Val = 0
    HYD button - pm4F4 = 305 0x4f4 WORD Val = 0
    FUEL Button - pm4F4 = 306 0x4f4 WORD Val = 0
    I can not configure with the values of 302, 303, 304 etc - (in the parameters)Because the rest of the values are exactly the sameHow to configure these buttons through offset?
    Can you give me a hand?
    See the example pictures.
    Attached Images Attached Images

  2. #2
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Jul 2017
    Location
    miami
    Posts
    7
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Offsets Airbus Project magenta - help

    I am not sure what these values mean.
    pm4F4 = 301.
    pm4F4 = 302
    Those values 301, 302,303 etc
    There are 12 buttons that are in the same offset, with values of parameter 0.
    How do I set up 12 functions exactly the same ??? Fsuipc will only enter one. This I do not understand.